I've got an old motor, it runs, that's good. Where can I get some sort of manual for this? Only "number" on it is on top of the transom clamp, below the carb, #164041, which doesn't seem to match with ANYTHING. I understand it was made by Eska, and possibly has a Tecumseh motor. I can't even find out for sure what year it is.
Where can I get a simple carb kit, with O rings or gaskets, as the carb bowl seems to leak at the push in drain button, or the big seal of the bowl itself.
Can I buy just the impeller somewhere? I've seen whole pump setups, but a free motor shouldn't require $40 for the impeller, or so I'm hoping.
Does the water pump only work when in gear, as I read somewhere in my research?
What does the adjustment screw at the bottom of the carb bowl (in the nut/jets that hold the bowl on) do? Main jet? Where is a good starting point to get it running and then adjust?
Lastly, can I get a PDF or other electronic format of the manual? (Again, haven't been able to find the serial/model/??? number 164041 on the plate on the transom clamp. All writing that was painted on the plate riveted there has worn off.
Thanks!
Where can I get a simple carb kit, with O rings or gaskets, as the carb bowl seems to leak at the push in drain button, or the big seal of the bowl itself.
Can I buy just the impeller somewhere? I've seen whole pump setups, but a free motor shouldn't require $40 for the impeller, or so I'm hoping.
Does the water pump only work when in gear, as I read somewhere in my research?
What does the adjustment screw at the bottom of the carb bowl (in the nut/jets that hold the bowl on) do? Main jet? Where is a good starting point to get it running and then adjust?
Lastly, can I get a PDF or other electronic format of the manual? (Again, haven't been able to find the serial/model/??? number 164041 on the plate on the transom clamp. All writing that was painted on the plate riveted there has worn off.
Thanks!