This happened 1st time as I was loading the boat. Spent about 4 hours on the lake the other evening, went to load the boat on to the trailer, during idle while in the water, it died. No power, no tilt. Found the 10amp fuse blown, and replaced it. Good to go. Today went back to the lake, as I was launching, the boat started flawlessly in the water, and idled well in neutral. When I engaged the remote into reverse, it died immediately. Pulled the boat out, fuse was blown again, and I replaced it. Tried one more time, and ditto. In the driveway moments ago, replaced the fuse again, with no engine running, I turned the key on (not to start). Moved the remote levers into Forward, and the fuse blowed again. I have searched these forums, and have not found anything that matches my problem. Any suggestions?