Hi,
I need to change the sealing ring on the shaft of my Bukh DV10 saildrive, since it is leaking oil. I know the right way would be to screw off the lower saildrive-housing, and then change the seal. But the six screws holding the housing are totally rounded off, there is no way of getting them out without damaging the housing.
So my question is: Is there a chance of changing the seal from the outside, after removing propeller and zinc anode? I have attached an explosion view, the sealing ring is no 20 there.
Thanks for any help!
Michael
I need to change the sealing ring on the shaft of my Bukh DV10 saildrive, since it is leaking oil. I know the right way would be to screw off the lower saildrive-housing, and then change the seal. But the six screws holding the housing are totally rounded off, there is no way of getting them out without damaging the housing.
So my question is: Is there a chance of changing the seal from the outside, after removing propeller and zinc anode? I have attached an explosion view, the sealing ring is no 20 there.
Thanks for any help!
Michael