Logo
Results 1 to 3 of 3
  1. #1

    Default need to purchase a needle and parts for my Clinton K500 carburetor

    Does any one know where I can find or purchase carburetor parts for a Clinton Ward Sea King 5 boat motor. I purchased a boat here in OK recently that has this engine on it. A needle is missing out of the bottom the carburetor. I have looked all over the internet and can not find any carburetor parts readily available for this specific engine. Thanks.
    - Nathan

  2. #2
    Join Date
    May 2009
    Location
    Quartzsite, Az, usa
    Posts
    489

    Default Re: need to purchase a needle and parts for my Clinton K500 carburetor

    You may end up at the lawnmower repair place. That carb was used on many lawnmower and garden equipment. Also watch for the gasket which sometimes went inside the carb bowl between the bowel and the carb where the jet screws into. You might expand your search for "Tecumseh", and other makes in the same category (air-cooled outboards) as many of the manufacturers used the same parts.

  3. #3
    Join Date
    Aug 2010
    Location
    Bank of the Ohio river
    Posts
    138

    Default Re: need to purchase a needle and parts for my Clinton K500 carburetor

    clinton engine products co.
    605 e. Maple st. Po box 860
    maquoketa, iowa 52060-0860
    (563) 652-2411
    you may have to keep trying the number, they say it not manned all the time

Similar Threads

  1. Montgomery Ward Sea King 1973 5 HP Clinton K500
    By technoid in forum Clinton Outboards
    Replies: 2
    Last Post: 01-02-2011, 05:52 PM
  2. ClintonSea King K500
    By sailingharry in forum Montgomery Wards Sea King
    Replies: 3
    Last Post: 01-10-2010, 02:32 PM
  3. Montgomery Ward Sea King 1973 5 HP Clinton K500
    By technoid in forum Montgomery Wards Sea King
    Replies: 1
    Last Post: 10-02-2009, 06:10 AM
  4. Rebuilding 1978 Johnson 15HP Carburetor Needle valve question
    By dtmolt in forum Johnson Evinrude Outboard Archive
    Replies: 3
    Last Post: 04-29-2009, 10:19 PM
  5. Looking for a place to purchase parts
    By mikemacy in forum Johnson Evinrude Outboard Archive
    Replies: 6
    Last Post: 04-28-2007, 07:52 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •