HarryCarry
Member
Anyone have advice on clearing a clogged rectangular strainer screen. I tried probing around from above and below with a coat hanger, scraper and a wire brush but was unable to get sufficient water flow for engine cooling. The water is just coming out at a slight trickle. I think the restriction was caused by corrosion. I believe the strainer is an BUCK ALGONQUIN rectangular with a replaceable perforated screen. I have two thoughts, one is to blow it out with compressed air by making a fitting for the seacock and the other is to drill through the screen from above. Anyone have any suggestions where I don't have to haul out the boat?
Thanks, Harry
Thanks, Harry