10 and 8 pin connectors

O

ocbd

New member

• Jul 2, 2010

• #1

I,m looking for a source for the 10 pin and 8 pin connectors. 2003 5.0 EFI
Thanks in advance.

Ed

 

makomark

Silver Medal Contributor

• Jul 2, 2010

• #2

Are you looking for the ones molded into the end of the engine harness?

 

O

ocbd

New member

• Jul 2, 2010

• #3

Yes, 10 pt on one end 8 pt onthe other, Thanks

Ed

 

knuckle47

Advanced Contributor

• Jul 2, 2010

• #4

I have been looking for them also...So far , No luck

 

linesix

Advanced Contributor

• Jul 2, 2010

• #5

Don't know which end you need but this might helphttp://cgi.ebay.com/ebaymotors/ws/e...4ffb8c355&rvr_id=&ua=WVF?&itemid=200284148727

 

makomark

Silver Medal Contributor

• Jul 2, 2010

• #6

I've only seen them as pigtails. If you replace both sides, you wind up with 16 crimps. If you eliminate the connector, you only have eight...if you do them correctly, you can also eliminate eight potential failure points.

 

knuckle47

Advanced Contributor

• Jul 3, 2010

• #7

The only reason I hesitate to just go direct....SOMETHING just tells me I will need to UNPLUG it again sometime in the future. And knowing the way things work with ME...It would be only a few days after I finished the job !

 

O

outriggers

Guest

• Jul 4, 2010

• #8

If you are looking to change over from the round 10 pin connector tor the square/rectangle connector on the newer crusaders Crusader sells a cable to do it. The sent me one free of charge when I put my 8.1l in. nad asked about it.

 

knuckle47

Advanced Contributor

• Jul 4, 2010

• #9

I don't know about OCBD but I am looking for the pieces to make my own connectors. Some of the older jones plugs I have found are not water resistant or corrosion proof.

Frankly I could care less whether or not they were triangluar or trapezoidal...If I can put 10 of my own wires in, I'm happy