I need to clarify something. Last night I went down and installed a new set of points. I had to do this because the set that was installed was acting weird. I would gap them set the dwell adjust timing. Run the engine for about 10 minutes life was good. Shut down try to restart and no start. Once I installed the new points and set everything right life was good. Now my question. Why won't I see 9 volts on the - side of the internal resistor coil. The coil is a 3 ohm internal resistor coil. I just want to make sure I'm not over driving the points. I do have an Oscope and could put it on but I'm not sure what I'm suppose to see.