Logo

wire diagram

frogman

Contributing Member
i have a 1975 evinrude and i need to know if there is a site i can go to see a wire diagram for tilt and trim system {to the relay box ,then to the toggle switch ect...... thanks !!!:)
 
I have generic diagrams on how TnT is wired. You would need to layer in any sensors, limiters, and extra switches. For direct wiring 10 or 12AWG. For relay wiring 22awg control wire and fused 20A relay output on a short 14awg whip (starter circuit is the typical source of the trim relay hi-amp input)
1w_direct.gif
1w_relay.gif
 
Last edited:
Back
Top