My SeaRay 340 sedan is equiped with 2 TAMD 41 A an MS4A reverse gear.
On the starbord engine I had to change the silent blocks because two of them have been bad. So I decided to buy 4 new ones (aftermarket). They are a little higher, than the original ones (ca 10 mm). When shaft is disconected everything runs fine, when shaft is connected and spinning I got vibration.
So I googled ... theoretical helpfull ... but
My problem is to center the shaft...
I can move the shaft vertical about 5 cm and horizontal about 8 cm.
The shaft sealing is a manecraft deep sea sealing
The boat is in the water
any advise?
KLAUS
On the starbord engine I had to change the silent blocks because two of them have been bad. So I decided to buy 4 new ones (aftermarket). They are a little higher, than the original ones (ca 10 mm). When shaft is disconected everything runs fine, when shaft is connected and spinning I got vibration.
So I googled ... theoretical helpfull ... but
My problem is to center the shaft...
I can move the shaft vertical about 5 cm and horizontal about 8 cm.
The shaft sealing is a manecraft deep sea sealing
The boat is in the water
any advise?
KLAUS