"I have a 9.8 that I am mounti
"I have a 9.8 that I am mounting on a Mirrocraft with factory side console. The shaft, that the motor pivots on and the steering shaft slides through, is not long enough. When turning the wheel hard over the steering shaft extends beyond the end of the pivot shaft which then is unsupported and will not return back without being aligned. Its seeems that I either need a longer pivot shaft or an extension on the side that the steering cable screws on. Anyone know of this issue? I was going to simply going to fab extension but the pivot shaft threads are not 1/2 pipe thread which I thought they were."
"I have a 9.8 that I am mounting on a Mirrocraft with factory side console. The shaft, that the motor pivots on and the steering shaft slides through, is not long enough. When turning the wheel hard over the steering shaft extends beyond the end of the pivot shaft which then is unsupported and will not return back without being aligned. Its seeems that I either need a longer pivot shaft or an extension on the side that the steering cable screws on. Anyone know of this issue? I was going to simply going to fab extension but the pivot shaft threads are not 1/2 pipe thread which I thought they were."