Logo
FULL SITE MENU

Heat exchanger bracket seperated

B

bobct

Advanced Contributor
"I took my port side H/E today

"I took my port side H/E today and the tank is separated/broken from the bracket. There's no damage, they're just not attached. I think it's been like this for a while and the hoses were holding it in place. Even like this the weight of the tank was still supported.

How would you guys fix it? It looks like someone (maybe when new) used some type of epoxy or adhesive.

It's not welded to the tank is it? Could I use something like 3M 5200?

Bob"
 
"I had mine off only a few we

"I had mine off only a few weeks ago and I don't recall BUT I THINK they are brazed to the metal bracket. The tank is copper and that 1/4" thick bracket is steel. With all the heat and vibration, I think this is your only option. Those other things will not hold up at all."
 
"You're right Rich, Did no

"You're right Rich, Did not think about the word braze. (English is second language for me).

Henry G"
 
"Had same thing happen, get so

"Had same thing happen, get some JB Weld from local auto or hardware store, clean surfaces and good as new. Fixed mine 4 yrs ago and still holding strong."
 
"My three faithful friends: du

"My three faithful friends: duct tape, silicone and J B Weld!

Where would we be without them?

Jeff"
 
"RM - thanks, I went and had i

"RM - thanks, I went and had it welded. I would have tried JB Weld if I saw your post earlier though
"
 
Back
Top