"I recently bought a used Hond
"I recently bought a used Honda BF40A, and I am trying to hookup a new Honda (Faria) Tach to the supplied used harness. The Tach instructions say to use Honda jumper wire 32197-ZH8-003 on "older tiller models". I found a picture of that "tiller model" jumper on the Honda website, and it looks like that jumper is installed on my harness. But when I connect that wire to the tach, I don't get any tach indication when I start the motor. See attached photo. Tach instructions say that BF40/50 require 06383-ZV5-316 Tach Kit, but I can't find any info on that part on the web, or where to get it. Do I need the "tach kit" if I have the "tiller jumper"? Also, there is an unused 3-pin pigtail at the motor end of the harness (see add'l photo) - what does that go to?
BF40A tach hookup to harness"">
BF40A harness engine connection
"I recently bought a used Honda BF40A, and I am trying to hookup a new Honda (Faria) Tach to the supplied used harness. The Tach instructions say to use Honda jumper wire 32197-ZH8-003 on "older tiller models". I found a picture of that "tiller model" jumper on the Honda website, and it looks like that jumper is installed on my harness. But when I connect that wire to the tach, I don't get any tach indication when I start the motor. See attached photo. Tach instructions say that BF40/50 require 06383-ZV5-316 Tach Kit, but I can't find any info on that part on the web, or where to get it. Do I need the "tach kit" if I have the "tiller jumper"? Also, there is an unused 3-pin pigtail at the motor end of the harness (see add'l photo) - what does that go to?