Logo
FULL SITE MENU

Evinrude 2000 70hp 4 stroke

T

tex11252

New member
I have a 2000 4stroke 70 hp. I

I have a 2000 4stroke 70 hp. It is hard to start and will run a few seconds and then die. I have a diagnostic cable from evinrude that is a 3 wire system. This cable is not for my engine. My engine takes a four wire cable. Everything checks ok with the ohms meter. The crankshaft sensors are about .010 too close.Will this affect the idle? If someone has the pin configeration for the 4 wire cable it would be a great help.
thanks
tex11252
 
I GUESS IF NO ONE HAS THE COLO

I GUESS IF NO ONE HAS THE COLOR CODE FOR THE PIN ON THE OUTBOARD DIAGNOSTIC CONNECTOR TO THE SERIAL CABLE CONNECTOR I WILL TRY CONNECTING THEM TO ONE OF THE PINS. HOPE IT DOES NOT BLOW IT`S BRAIN.
 
"THIS IS THE ROUND CONNECTOR O

"THIS IS THE ROUND CONNECTOR ON THE OUTBOARD WITH FOUR WIRES GOING TO IT. I HAVE THE THREE WIRE CONNECTOR, BUT THE CONNECTOR IS DIFFERENT. IT IS A TRIANGLE SHAPE AND A 9 PIN SERIAL CONNECTOR ON THE COMPUTER SIDE. I TRIED THE THREE WIRE CABLE AT THE EVINRUDE DEALER AND HE SAID HE COULD NOT CHECK IT WITH HIS CABLE. HE HAD THE ROUND CONNECTOR BUT IT WAS CONNECTED WITH THREE WIRES.
MY OUTBOARD HAS FOUR WIRES THAT COMES TO THE CONNECTOR.
THANKS FOR YOUR HELP.
ROY"
 
Back
Top