Logo

MAGNETS FLYWHEEL

dalejr33

New member
I have a 1986 Evinrude 225 tha

I have a 1986 Evinrude 225 that I had to pull Flywheel off to replace Timing Base and 2 magnets came unglued. Now can I reglue them back on?? If so what glue do I use??

Or do I have to buy new Flywheel?

Thanks Dave
 
"you can glue them on, a high

"you can glue them on, a high quality thin 2 part epoxy works best. I've done it a few times with no problems."
 
"As Brian states, a two part e

"As Brian states, a two part epoxy glue does the job BUT whaT I've used in the past was the epoxy purchased at the dealership and it was a heavier thick mixture..... most likely available just about anywhere.

Use short pieces of 3/8" outside diameter fuel hose to keep the magnets separated."
 
Back
Top