Logo

35 HP Shift Detent Balls and Spring Installation

bigboater

New member
"Hey Everyone,

New to the


"Hey Everyone,

New to the forum and looking for some help here. I have disassembled the lower unit on my 78 35HP and am trying to reassemble the prop shaft. To do this i need to install the detent balls and sprin on the prop shaft and then thread through the yoke and clutch dog but I am to understand I need special tool OMC P/N 328081. Does anyone know how to accomplish this without that tool? Attached is a picture with the prop shaft and clutch dog already installed outside of the lower unit.
282240.jpg
"
 
Back
Top