Logo
Results 1 to 2 of 2
  1. #1
    Join Date
    May 2009
    Location
    , MN, US of A and proud of it
    Posts
    1

    Default "Hey Everyone, New to the

    "Hey Everyone,

    New to the forum and looking for some help here. I have disassembled the lower unit on my 78 35HP and am trying to reassemble the prop shaft. To do this i need to install the detent balls and sprin on the prop shaft and then thread through the yoke and clutch dog but I am to understand I need special tool OMC P/N 328081. Does anyone know how to accomplish this without that tool? Attached is a picture with the prop shaft and clutch dog already installed outside of the lower unit. "

  2. #2
    Join Date
    May 2008
    Location
    Morehead City, NC,
    Posts
    94

    Default "You might want to check out t

    "You might want to check out this posting from another forum ... http://forums.iboats.com/showthread.php?t=104363

    I've put one back together last year in my outboard repair class ... but from what I remember, it wasn't easy, even with the OMC tool!

    Good luck ..."

Similar Threads

  1. TStat check balls
    By dessie in forum Mercruiser Sterndrive Forum
    Replies: 14
    Last Post: 12-03-2009, 07:18 PM
  2. 1958 Evinrude starter spring assembly installation
    By frodo_3 in forum Johnson Evinrude Outboard Archive
    Replies: 4
    Last Post: 08-10-2009, 10:48 PM
  3. Cleaning detent ball and spring on a bravo
    By mnydvr in forum Mercruiser Sterndrive Archive
    Replies: 3
    Last Post: 05-19-2008, 06:15 AM
  4. Johnson J150TXCCA Shift detent spring amp ball
    By gene_boyett in forum Johnson Evinrude Outboard Archive
    Replies: 5
    Last Post: 10-23-2006, 06:45 PM
  5. Also Question about Spring and Balls under the Clutch Dog
    By drwiggle in forum Archive 2003-2009
    Replies: 1
    Last Post: 07-01-2003, 09:34 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •