Logo

Cooling water for PSS Dripless shaft seal from sportpac 350

B

billnetto

Guest
I have the Marine Power Sportp

I have the Marine Power Sportpac 350. I am looking for a location to install a fitting to cool my PSS Dripless shaft seal.
Has anyone done this ?
 
"If it is FWC you can come off

"If it is FWC you can come off of the currently plugged fitting in the bottom of the heat exchanger, if it has one. Make sure you plunge out the port to clear any scale which may be blocking it and flush it good. If RWC, come off of the bottom of the exhaust manifold, same thing goes for flushing this port."
 
Thanks for the info. It is FWC

Thanks for the info. It is FWC so I'll use the heat exchanger.
 
I had PSS installed recently.

I had PSS installed recently. The cooling line was run from the starboard drain plug on the forward heat exchanger. Engine temps didn't change.
 
Back
Top