Logo
Click for Chrysler parts and manuals!
Results 1 to 3 of 3
  1. #1
    Join Date
    Sep 2008
    Location
    New York, NY, USA
    Posts
    71

    Default "for the heat exchangers on my

    "for the heat exchangers on my 360's (the L shaped ones), do I need to drain everything to change the zincs? Never done this before. Also, where are the threads for the zincs - are they on a vertical piece of the unit or horizonal piece.

    Thanks all"

  2. #2
    Join Date
    Sep 2003
    Location
    New Tripoli, PA, USA!
    Posts
    15,190

    Default They look like a drain plug.

    They look like a drain plug.

    If you're quick fingered it can be done with minimal coolant loss.

    Jeff

  3. #3
    Join Date
    Dec 2008
    Location
    Posts
    149

    Default They should be brass plugs min

    They should be brass plugs mine were if you take out the plug have a cheap steel one ready to put in hole under the brass plug in the middle its threaded for the new pencil zinc it maybe plugged if its been a while clean it out good and thread in the new then reinstall just went through it....Hope that helps

Similar Threads

  1. Heat exchanger
    By jaynkay in forum Chrysler Inboard and Sterndrive Forum
    Replies: 4
    Last Post: 05-18-2009, 09:11 AM
  2. Heat exchanger
    By alexdyer in forum Mercruiser Sterndrive Archive
    Replies: 2
    Last Post: 07-17-2008, 06:45 PM
  3. Heat exchanger for an aq 125
    By cbdinak in forum Volvo Penta Gas Archive
    Replies: 2
    Last Post: 08-08-2007, 01:38 AM
  4. HEAT EXCHANGER IS GETTING HOT
    By erik32017tx in forum Mercruiser Sterndrive Archive
    Replies: 1
    Last Post: 09-13-2006, 09:37 AM
  5. Heat exchanger
    By mothy3 in forum Archive 2002-2006
    Replies: 3
    Last Post: 06-19-2003, 12:08 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •