Logo

1959 35 hp johnson

mike_swanson

New member
"I am rebuilding the the carb,

"I am rebuilding the the carb, putting in new coils and putting in a tune up kit. in order to do this I need to remove the flywheel off the top of the motor, Can anyone tell me what I am suppossed to torgue the flywheel too when putting it back on or do I just tighten it as tight as I can get it?
It's a 1959 35HP johnson super seahorse.

Thanx"
 
Hi Mike I was wondering if you

Hi Mike I was wondering if you could tell me where the small black wire on the top of the wiring harness inside the engine goes? I have a 59'Evenrude 35hp Lark.
 
"I need a little more info, I

"I need a little more info, I am assuming you are talking under the Flywheel, small black wire? is it attached to the coil?"
 
"The wire is coming off the pl

"The wire is coming off the plug/harness.On the same side as the shift lever,mounted on the side under the hood.It might go any where.But it's on the plug on the engine side.thanks for writing back!! Troy in Seattle."
 
Back
Top