Logo

2714e injector pump timing

jenny

New member
i have a minimec injector pump

i have a minimec injector pump.does any one know how to time this it says #1 spill time 20*degrees b.t.d.c. that is set by pump i know but the engine needs to be 20* btdc or at top dead center. i really could use the help thanks.thats on a ford 120 hp 2714e
 
"I posted this about a year ag

"I posted this about a year ago... I hope this helps.

Did this yesterday on my 120 2715-E. There is an aperture cover on the flywheel housing on the starboard side. A mirror and flashlight was a necessity to read the numbers. In my case; for some reason the flywheel was/is covered in rust; therefore, impossible to read the numbers. I had to push back the shaft and remove the tranny in order to access the flywheel. I was then able to clean the wheel enough to find the #. My manual states 20 degrees BTDC. My flywheel reads 19 & 21 - with just a mark for the 20."
 
Back
Top