colriverrat
Contributing Member
"Has anyone out there done an
"Has anyone out there done an overhaul on a 1980 2 clyinder DT65? I want to overhaul mine, bad lower rings will not idle. I found 99.9% of the parts at Browns Point, 1 single part is discontinued. It is a "labyrinth Seal Ring" it sets between the two cylinders. Is it and absolute "must" replace item???? It breaks my heart to think this motor will end up in a dumpster over such a small part.
I was able to find every single external gasket and seal along with new pistons and rings. All those combined will cost around $350. Is it worth spending that much money without replacing the labyrinth seal ring???"
"Has anyone out there done an overhaul on a 1980 2 clyinder DT65? I want to overhaul mine, bad lower rings will not idle. I found 99.9% of the parts at Browns Point, 1 single part is discontinued. It is a "labyrinth Seal Ring" it sets between the two cylinders. Is it and absolute "must" replace item???? It breaks my heart to think this motor will end up in a dumpster over such a small part.
I was able to find every single external gasket and seal along with new pistons and rings. All those combined will cost around $350. Is it worth spending that much money without replacing the labyrinth seal ring???"