Logo

If you need boat parts or diesel parts

B

Bill Crane

Guest
"I am looking for parts &

"I am looking for parts & information for an old MD 17. One of my customers has this engine in his boat. It is a salt water cooled model with an aftermarket heat exchanger conversion to fresh water cooling. The engine runs fine with the exception of exhausting blue smoke & residual deisel fuel. I think that it may be that the thermostat is the original for salt water cooling which opens at 140 degrees. Is there a thermostat which opens at 180 degrees to replace the original that will allow the engine to run a litter warmer & burn this residual fuel & hopefully eliminate or reduce the blue smoke? Please pass this message on to the 'powers that be' in the service 7 parts department - Thank you, [email protected]"
 
" I AM LOOKING FOR ANY PARTS T

" I AM LOOKING FOR ANY PARTS TO MARINEISE A BMC DIESEL MOTOR,ie JAPSCO MACANICAL WATER PUMP,HEAT EXCHANGER MANIFOLD,MARINE G/BOX ECT ECT.ANY INFO WELCOME "
 
" Anyone,

i am searching f


" Anyone,

i am searching for any information ( manual and/or technical information ) about ARONA AD-type engine.
I bought the engine without even knowing it's rotation direction. "
 
" HenkW,

Click on the "


" HenkW,

Click on the "keyword search" link on the left, and then enter "arona" into the search box. We have had various discussions here before about sources of parts and information for those engines.

Regards,
Andrew "
 
" CAN ANYONE PLEASE TELL ME WH

" CAN ANYONE PLEASE TELL ME WHERE TO SOURCE BMC 2.2
SPARES,MANY THANKS
KEN "
 
"I am looking to locate somebo

"I am looking to locate somebody who would have sleeve, piston and rings for a diesel motor Farymann k30m.
So I am looking to locate a dealer who sell those parts or would somebody have thoses pieces used in good condition...Thanks Maurice

[email protected]"
 
"Maurice,

Here are some lin


"Maurice,

Here are some links for Farymann.

You could get the same links by typing "Farymann" in the search box on our home page.

You could also post a wanted ad in our classifieds

Regards,
Andrew"
 
" BUKH DIESEL MOdel:DV10 S/No:

" BUKH DIESEL MOdel:DV10 S/No:206446
Need "GOOD" used cylinder head for DV10--
Part No: 000D8144. To replace current cracked head.
Will consider new part at "marine trade " cost.
Engine located Florida.Anxious to learn if available.Please email replies. April 1,2003 "
 
" Sidney Propeller has been se

" Sidney Propeller has been sevicing Farymanns for over 30 years, give Willie a call 250-656-3421 "
 
I have a Perkins 499 that I h

I have a Perkins 499 that I have been overhauling.I have done the head and all bearings in the lower end. 90% finished. I have now aquired another engine for my 18ft boat and now have this unwanted one. anyone interested?
 
Hi:
Does anyone know where I


Hi:
Does anyone know where I might be able to get a thermostat housing for a Volvo Penta MD5A diesel engine?
 
" We´d like to purchase

" We´d like to purchase a complete Graymarine Diesel Model Four-D-129 or starter for same engine.
The starter number is Delco-Remy Model 1108247
Thanks, Don Burns "
 
I'm looking for an oil pa

I'm looking for an oil pan for a Cat.3208T. Part #8N1651. Must be rust free.
 
I am looking for a used heate

I am looking for a used heatexchanger for a 3208 natural caterpiller
 
I am looking for a used heate

I am looking for a used heatexchanger for a 3208 natural caterpiller
 
I'm looking for head gask

I'm looking for head gasket and radiator cap for a Buda-Lanuva diesel engine Model #6-dt-468.This engine is in a Austin/western road grader.
 
" Looking for parts or rebuilt

" Looking for parts or rebuilt motor for Renault Marine diesel RC8D, single cyl, 8HP. "
 
Looking for parts for GM Bedf

Looking for parts for GM Bedford 500 diesel engine.
 
" Looking for any parts on Det

" Looking for any parts on Detroit diesel 8V53N marine. Need heat exchangers, manifolds (wet Exhaust) thanks "
 
I am looking for a technical

I am looking for a technical manual for cat. 3106TA's. Recently reengined with rebuilds and have no idea or operating requirements. Where can tech. manuals be found?
 
john armbruster

iam looki


john armbruster

iam looking for guages for my 1968 super 300 austin western road grader. also a front blade and a side blade. and a manual for my recently bought machine.
 
i am looking for water cooled

i am looking for water cooled exhaust manifolds and elbows for cat 3208 natural asp.
 
"Looking for parts for a TAMD7

"Looking for parts for a TAMD70C-VOLVO PENTA DIESEL heatexchanger,Flameglowplug,506-twin disc reverse gear etc."
 
Back
Top