Logo

130 problems

free

New member
"Just replaced the head and no

"Just replaced the head and now have a couple of problems,will not come up to full power now (no tach)last 1/3 of throttle does almost nothing,compression is 225 on all,all plugs are firing but #1 is smutted up bad after a hour.When I was ready for a test run found the fuel pump would not energize and had to straight wire it through a toggle switch,tried to reset the ECM and no luck,MIL light wont come on and no beep beep when done,swapped ECM's with a spare and it's the same. Almost to the point of useing the BFH to work on it with.
angry.gif
"
 
check all connections
i have


check all connections
i have seen the MIL light connection on back of the panel fall off
 
"I put a new key switch,lights

"I put a new key switch,lights and harness on it,still no luck with the MIL,resetting the computer or energizing the fuel pump, but I did find out why I didn't have but 2/3rds power,after 2 or 3 test runs it was chattering loud so I pulled the valve cover back off and 14 of 16 valve lock nuts had backed off and were in the oil pan."
 
Back
Top