"I replaced a impeller due to
"I replaced a impeller due to no flow. I found bits of an old impeller stuck in the housing, cleaned it out but still no flow. The water drips out the exit tube. I used the wash out hole and a hose and only slightly better flow from the exit tube. I don't know where to look or how to test. Do I use compressed air into the exit tube?
The motor looks like it never was used or in the water. The chopped up impeller bits puzzle me and the impeller I replaced looked new. Someone worked on it and ebayed it to me. I used it about an hour before the water stopped flowing. It wasn't squiting out very strong and the seller sent a fresh impeller with the motor. I am stumped but can guess there are some bits clogging the flow. How to fix?
Thanks"
"I replaced a impeller due to no flow. I found bits of an old impeller stuck in the housing, cleaned it out but still no flow. The water drips out the exit tube. I used the wash out hole and a hose and only slightly better flow from the exit tube. I don't know where to look or how to test. Do I use compressed air into the exit tube?
The motor looks like it never was used or in the water. The chopped up impeller bits puzzle me and the impeller I replaced looked new. Someone worked on it and ebayed it to me. I used it about an hour before the water stopped flowing. It wasn't squiting out very strong and the seller sent a fresh impeller with the motor. I am stumped but can guess there are some bits clogging the flow. How to fix?
Thanks"