"OK ran into a dead end so goi
"OK ran into a dead end so going to where I should have started...... with you guys!! I have a KAMD-43P. The wiring harness that comes from the dash to the ECM (control box with the reset button)has a molex plug. Who ever rebuilt the engines pulled out all the pins when removing the engine, then tried to crimp them back on when the motor was re-installed and buggered them all up. Bottom line is the pins are .062 in size but very long, 1 1/8". Bought some on-line, they are the same diameter but only 3/4" long. Searched all over the web with no luck. Anyone have any idea where to get these pins or a least where to get a replacment connector?? Thanks guys!!"
"OK ran into a dead end so going to where I should have started...... with you guys!! I have a KAMD-43P. The wiring harness that comes from the dash to the ECM (control box with the reset button)has a molex plug. Who ever rebuilt the engines pulled out all the pins when removing the engine, then tried to crimp them back on when the motor was re-installed and buggered them all up. Bottom line is the pins are .062 in size but very long, 1 1/8". Bought some on-line, they are the same diameter but only 3/4" long. Searched all over the web with no luck. Anyone have any idea where to get these pins or a least where to get a replacment connector?? Thanks guys!!"