Logo

1993 Mariner not getting water outof the weep hole

jonboy1518

New member
I just replaced the impeler an

I just replaced the impeler and tried to run it. no water came out of the weep hole. all of the lines are on in the cowling. but i'm not sure if i got the line on right on the water pump. any tricks to get it on? when i put the lower unit back on i couldn't see the line. is there any way to extend the line down? any help would be great.
 
"there should be a pipe that s

"there should be a pipe that slots into the top of the water pump it should be clearly visible when the lower unit is removed. when u put the lower unit back on it should slot into the top of the water pump outlet, sometimes they can move to the side and the lower unit can still go back together but the pipe will be misaligned."
 
"also u could have old bits of

"also u could have old bits of impeller stuck in water lines, check the tell tale outlet line for blockages. and also remove the grill from the bottom of the lower unit where the inlet is as sometimes gunk and old bits of impeller can fall down there and stop water from being sucked into the water pump."
 
Back
Top