Logo

Tilt issues 200HP evinrude falls down

searay123

Contributing Member
"Seems the tilt when going up

"Seems the tilt when going up was making some noise , It will go up and down yet falls down after the trim pins go down down . Is there a kit to rebuild the center cylender? Any sugestions on how to do ? need special tool ? help find diagrams ?"
 
"i dont see your year model...

"i dont see your year model......but,u can rebuild the cyl's...and about the only special tool on the fastrac sys..is a pressure gauge,and a cpl of sleeves....old style,same but w/a valve tester,a large 'nut' that u screw valves into...to test.I suggest a FACTORY----service manual ,...for sure.cleanliness on these units cannot be stressed enuf when rebuilding.take a good look at your trim motor,..NOW is the time while off,if it may be borderline shape."
 
Back
Top