A
Alan R Wilkerson
Guest
large cylinder in the tilt/tri
large cylinder in the tilt/trim assembly has a (approximately) 1/2" pin with a slot on the port side that goes through a sleeve at the top of it .There is a small 1/8" pin run through the middle of it perpendicular to the larger pin.How do you remove the small pin first then how do you remove the large pin.
large cylinder in the tilt/trim assembly has a (approximately) 1/2" pin with a slot on the port side that goes through a sleeve at the top of it .There is a small 1/8" pin run through the middle of it perpendicular to the larger pin.How do you remove the small pin first then how do you remove the large pin.