tboltmike
Regular Contributor
"The factory tilt and trim mot
"The factory tilt and trim motor (1975, 115 Johnson) is getting weak and I am toying with idea of installing a CMC 130 unit. However, I am concerned about it moving the engine 5 or so inches aft of the transom. It seams to me this will add a bending moment to the transom and add stress to it not to mention the offset forces of thrust and turing. The transom is in good condition but it is a 33 year old boat too.
Should I be concerned about this or are the added stresses neglible?
CMC indicates that an improvment in performance can be expected because the motor can be raised higher.
Any input is appreciated? Thanks, Mike"
"The factory tilt and trim motor (1975, 115 Johnson) is getting weak and I am toying with idea of installing a CMC 130 unit. However, I am concerned about it moving the engine 5 or so inches aft of the transom. It seams to me this will add a bending moment to the transom and add stress to it not to mention the offset forces of thrust and turing. The transom is in good condition but it is a 33 year old boat too.
Should I be concerned about this or are the added stresses neglible?
CMC indicates that an improvment in performance can be expected because the motor can be raised higher.
Any input is appreciated? Thanks, Mike"