danjmartin
New member
" Question for joe or anyone w
" Question for joe or anyone who may help!
I had to change a piston and ring on my 1978, 140 HP Evinrude outboard (high ring, curled piston, previous post).
A friend mentioned a break-in period/procedure for new rings. Something about keeping the motor below a set RPM for a set period. Does anyone have any information on this? I did a lot of work here and don't want to mess it up on the last step!
Thanks,
Dan "
" Question for joe or anyone who may help!
I had to change a piston and ring on my 1978, 140 HP Evinrude outboard (high ring, curled piston, previous post).
A friend mentioned a break-in period/procedure for new rings. Something about keeping the motor below a set RPM for a set period. Does anyone have any information on this? I did a lot of work here and don't want to mess it up on the last step!
Thanks,
Dan "