Logo
Results 1 to 2 of 2
  1. #1
    Join Date
    Feb 2008
    Location
    , Queensland, Australia
    Posts
    4

    Default "I'm working on a Johnson

    "I'm working on a Johnson 115hp (1975), just put in new rings and piston as it overheated, everything looks good in the engine, looked for melted wires and repaired, at some time the trigger and power pack was replaced, the problem is it starts and runs fine for`a few seconds but then stops dead as if the timing altered but there was no movement on the trigger advance lever and it did not seize in the engine as you can turn the flywheel straight away. Hope someone can help thanks.Scotfree"

  2. #2
    ikia's Avatar
    ikia Guest

    Default Put a timing light on it to se

    Put a timing light on it to see if it is an ignition fault when it quits.

Similar Threads

  1. Need some Help - 1975 115hp
    By a1bukk in forum Johnson Evinrude Outboard Forum
    Replies: 7
    Last Post: 08-14-2010, 12:30 AM
  2. 115HP 1975 Evinrude Choke Problem
    By dick_j in forum Johnson Evinrude Outboard Archive
    Replies: 1
    Last Post: 06-08-2008, 12:02 PM
  3. 1975 115hp where to start
    By huntinjerk in forum Johnson Evinrude Outboard Archive
    Replies: 2
    Last Post: 03-02-2008, 06:16 PM
  4. 1975 Johnson 99
    By jeffro_2007 in forum Johnson Evinrude Outboard Archive
    Replies: 0
    Last Post: 08-09-2007, 09:35 PM
  5. 1975 Johnson 115HP is there a rev limiter
    By roger in forum Outboard motors archive 2000-2004
    Replies: 1
    Last Post: 09-20-2001, 11:55 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •