Logo

Alpha 1 trim sender and limit switch

jerryh

Member
"How do I remove these from th

"How do I remove these from the bell housing? Also I took the cover off the trim sender to see what to clean so the trim gauge would work and There is'nt any guts inside, no electrical components. Do I have a dummy sender? the wires are just screwed to the cover."
 
"limit switch in on the left s

"limit switch in on the left side, and yes, you could have a dummy installed by the factory."
 
"On topic question:

How har


"On topic question:

How hard is it to install and hook up a trim gauge on an Alpha1 if the boat never came with one? Anybody know where to buy the gauge and parts I would need. The outdrive already has a limit switch on the port side and something else, maybe a 'dummy' sending unit on the starboard side. Thanks."
 
"I installed gauges on an 87 5

"I installed gauges on an 87 5 Litre and a 92 3 Litre. In both cases the wiring harness had the lead right to the helm so it was just a matter of locating it and hooking up the gauge. I am not certain, but I think that is the normal situation so with a wiring diagram you should have no problem."
 
Back
Top