Converting manual lift to auto matic or hydrolic lift

well it is apparent that no o

well it is apparent that no one knows how to repair manual trim what would it take to convert the boat to hydrolic trim? have a 89 17 foot tracker with 40 hrp motor not much room inside thanks ! is it expensive?

You are talking a ton of mone

You are talking a ton of money and a ton of work....! Whats wrong with your manual...?

" auto trim is doable with the

" auto trim is doable with the use of a CMC jack plate Pi\urchable From CAbelas or BASS PRO, for around 500 bucks, as long as your tilt tube isnt sceezed all you should have to repair on your tilt is the hydrolic lift shocks and maybe the reverse tilt lockout function.

your best bet ts the CMC TRANSOM JACK for smaller outboards if it has thumbscrews, if it has the standard ABYC engine bracket they also make one for up to 130 hp as well, You will gain a little preformance with the jackplate as well and it is very easy to install, simply support the outboard with a hoist or cherry picker and remove the mounting bolts, install plate with existing fastiners and install outboard in same relative location on jackplate tourque all bolts and enjoy. "