Logo
FULL SITE MENU

Search results

  1. M

    Are all single engine setups standard rotation?

    Read the original question
  2. M

    1978 OMC 240 HP Ford 5.7 liter-can I replace OMC outdrive with Mercruiser?

    This would be a correct example of a "non-structural" transom (as it is detached from the rest of the hull),
  3. M

    1962 283 owen flagship cooling system

    Your pump appears to be the rotary gear type
  4. M

    help Identify upper unit gear set, Mercruiser MC-1 (Early)

    Some twenty years ago my neighbor's friend let his 60's era 120 engine freeze. They did a complete re-power and I bought the old engine and drive for parts. Left over is the "leg" {unmolested). I will be in Banks, Oregon on the 13th of August. Meet me there with two six packs of Widmer's Hefe...
  5. M

    350MPI - Black Scorpion Base Engine?

    Scott, I would also be interested in seeing what your pistons look like. I would especially like to see the pistons in Quenchmaster Rick's 5.7s. Probably OEM deep dish. Here is one of mine, not OEM.
  6. M

    no drive

    If what you state is true "so shaft turns,but no water pump or gears" and you have a drive earlier than an Alpha, your lower unit input shaft may be sheared off at the "O" ring groove (not uncommon).
  7. M

    Prestolite Distributor Governor Springs

    The only new replacement springs that I found that were compatible. Available here and in limited quantity. https://www.marineengine.com/parts/omc-parts/omc-boat-parts.php?year=1987&hp=5.7&model=574AMFTC&manufacturer=OMC+Stern+Drive&section=Distributor+-+Prestolite+Ibm-7013c Originals...
  8. M

    age old carb debate sorry guys

    Carb #17086116, Motor was painted black from factory.
  9. M

    1976 CHRYSLER 400 Where do I connect hoses for water heater?

    Both hoses go to the water pump housing
  10. M

    Identify the year

    How about this one.
  11. M

    Chrysler LM318BXRX-036

    The hole in the "little tab" is zero. 5/8 inch equals 10 degrees.
  12. M

    chrysler 318 new intake manifold

    A little careful cutting and welding should be successful.
  13. M

    Chrysler inboard motor identification

    Does ti look similar to this photo?
  14. M

    Chrysler crank pump drive drawings 318 to 440

    I have gone ahead and had an adapter made up. My engine did not come with a raw water pump, It was delivered to be supplied by the outdrive's pump, not adequate for a full closed system. The crankshaft option with the Johnson pump is slightly less expensive than rounding up a belt driven...
Back
Top