Logo

Search results

  1. M

    2005 Honda BF115A Cover Under Seal

    The tape seal on my BF115A between the plastic under cover and the case extension has gradually worked out after I installed a new foot several years ago. The seal appears to be a clear vinyl adhesive tape with a black line on and is listed in the parts manual as a "seal B, cover under", part...
  2. M

    97 Honda BF90 Keyswitch Wiring

    In the off position the key switch wiring diagram shows the black wire (negative-ground) and the black/red (ignition) wire connected. Is this a safety feature that grounds out the coil(s) on the engine so that it can't be started by accident? The black/red wire is also shown as the emergency...
  3. M

    1997 Honda BF90A Voltage Gauge Fluctuating

    1997 Honda BF90A. Voltmeter and Tachometer acting strange. At idle, approximately 900 RPM, boat voltmeter and tachometer appear to give accurate readings. As RPM is increased boat voltmeter voltage drops and tachometer fluctuates. Thought voltmeter was bad so connected Fluke multimeter to boat...
  4. M

    BF90A Timing Belt Replacement

    I've got a 1997 Honda BF90A and am attempting to replace the timing belt. Problem is I can't get the 17mm pulley/alternator rotor bolt out. Tried breaker bar and impact wrench without success. Is this a reverse thread bolt? Any suggestions?
  5. M

    1998 Honda BF90A Won't idle.

    1998 HondaBF90A. Rebuilt carburetors this summer and motor ran like a dream for severalmonths. Last time it was used was about a month ago and it ran good. Tried to start it this weekend and itsputtered and kept cutting off. It will run with full choke and partialthrottle but when throttle is...
  6. M

    No light at the end of the tube

    Got a 1998 Honda BF90A that set up for a while. Ran pretty good a couple of weeks ago but started sputtering the other day. The only way I can keep it running is to continue to pump the throttle. First thought bad gas. New gas didn't help. Second though clogged fuel filter. New fuel filter...
  7. M

    Honda BF115A Malfunction Indicator Light (MIL) Connector

    Honda BF115A Malfunction Indicator Light connector. Everything I see in the wiring diagrams shows a three pin MIL connector with Yel/Blk, Wht/Blu and Red/Blu wires. I can only find a six pin connector on the motor right next to the 14 pin main control connector. The six pin connector has...
  8. M

    Honda BF115A will not start

    :( 2004 Honda BF115A ran good two weeks ago. This weekend tried to start and starter worked, motor turned over but will not start. Battery good, battery cables to engine good (new connectors), voltage 12.7 v with ignition switch on. When ignition switch turned to start voltage drops to 9.6 v. No...
Back
Top