Logo
FULL SITE MENU

Search results

  1. circle hook

    limited RPM 3,800

    good morning my problem is that I had a bad switch box to start, I changed it to find that the high speed stator side was also burnt out limiting the engine only to 1,000 rpm then stalling. with the stator, and both switch boxes changed I went to start it and it and it raced at 2,000 RPM at...
  2. circle hook

    3,500 max rpm

    Hello I used to have 4,800 to 5,200 rpm before replacing my stator & both switch boxes, now I only get 3,500 rpm. is there anything I am over looking all my DVA readings are good and the bias is good also. what could of I done wrong it was cut clean color for color on all the wires, and the...
  3. circle hook

    bad switch box

    does anyone know what the major cause to burn out a switch box, I have a 1990 135 HP mercury and 5 years ago I bought it with a bad switch box, I changed it and now 5 years later I burn another, I don't remember if its the same one, inside or outside, but what causes a switch bot to go. is...
  4. circle hook

    stator size

    hello I have a 1990 135HP mercury how do I tell if I have a 16 amp or 40 amp stator, the windings are copper and not covered in plastic I believe its a 40 amp but not for shur. thanks Bob
  5. circle hook

    3 1/2 HP Mercury Lower unit

    Hello I have a 3 1/2 HP mercury and I think the drive shaft is stuck in the crankshaft, any ideas on how to free this without beating and braking the alummium lower housing. I alao can not seem to be able to find the year of this engine it has a netural shift lever but no opening to disconnect...
  6. circle hook

    3.5 HP lower unit stuck

    Hello I think the drive shaft is stuck in the crank shaft but I don't want to beat in the alummium housing and brake it any other thoughts on how to free this thing up, and I can not seem to be able to find the year on this engine. Its a 3 1/2 HP mercury Serial# 6336982 it has a netural shift...
  7. circle hook

    factory manual

    does anyone know a site for factory marine power engines manuals: MOD. NO. MP350ANS SER. NO. AN89033612S MARINE POWER INC.
  8. circle hook

    siezed engine

    hello I have a seized 350 it was said its seized from sitting to long I've tried marvel oil, PB Buster, and a 1/2" braker bar with do luck. I was told buy an old timmer to try pepsi-cola. does anyone have a idea that may work, I really don't want to snap the damper bolt off. there was no water...
  9. circle hook

    1979 9.9 fuel pump

    does anyone know where I can find a better detailed schematic of the fuel pump brake down, the one I got was completely taken apart and there is a spring inside I don't know for shur on what side it comes from. I like taken pictures before taking apart any thing but I got this one in pieces...
  10. circle hook

    9.9HP conversion to 15HP

    Hello I just purchased a 1979 I believe to be a 9.9, the owner states it has a 15HP carburetor the serial plate is missing but the serial number on the block matchs a 9.9 how can I tell if this is true. the carb number to the best I can read is 388275. Thanks Bob
  11. circle hook

    reed valves

    how can you tell if the reed valves need to be replaced Thanks Bob
  12. circle hook

    318 engine replacement car engine to boat

    hello I have a 1972 318 engine in my boat and I am trying to sell my 1999 dodge Durango but no buyers so far, I was wondering if I could switch my exhaust, alternator, water intake pump, etc. would the engine bolt to my stringers,& transmission. the engine has very little miles and well taken...
  13. circle hook

    quick question spring lines

    what would be best for me spring lines from the forward poles to my mid cleats, or from the mid poles to my stearn cleats. I am trying to minimize the rubbing on the poles I kind of have a tight slip, a foot or less on both sides. Thanks Bob
  14. circle hook

    diesel rotation

    do diesel engines rotate like gas engines counterclockwise & clockwise, or do they rotate the same direction but the transmission change the direction Thanks Bob
  15. circle hook

    right & left hand tranmissions

    hello I have twin 318 Chrysler gas engines & want to switch to diesel engines, I have velvet ASI 71C transmissions & walter RV-20D "V" drives, I was wondering do the diesels counter rotate, or can I change the rotation tru the transmissions. I am looking to find a set of Chrysler CM6-55 diesels.
  16. circle hook

    chrysler replacment w/Hino

    hello I was told that the old bayliners, used Hino's and they were compatible with Chrysler, what I am trying to say I was told that a Hino would bolt right up to my bell housing, I wondering if so what would the engine number be so I can start looking for a set. I have 318,s Chrysler gas...
  17. circle hook

    chrysler diesels

    hello I was told there is a diesel engine that would bolt right up to my bell housing on my 1972, Chrysler 318's is this true and what engine, size & year am I looking for. there going in a 32 foot luhrs boat, that I want to covert from gas to diesel. without having to sell the house. can...
  18. circle hook

    chrysler diesel

    Hello I was told that Chrysler made a diesel engine that would bolt right up to my 1972 318 small block bell housing does anyone know what size & year these were made any info would be a great help. Thanks bob
  19. circle hook

    electrical fuel pump conversion

    hello I can not locate a fuel pump for my '1971' 318, so it looks as if I have to convert to electric fuel pump. when in stalling one do I need to reroute a line back to the fuel tank I was told. if so how do you do that. and does anyone know what is the best type, make ,model, to buy...
  20. circle hook

    make & year of my engine

    hello I just bought a shamrock boat & it came with a engine MOD NO MP350ANS SER NO AN89033612S MARINE POWE INC. can anyone help me with manufacture & year Thanks bob
Back
Top