Logo
FULL SITE MENU

Search results

  1. R

    Air horn not loud

    On 46 searay sun dancer the horn is not loud enough by hooking up direct compressed air to horns ,it's loud anyone know where the air compressor is located for horn? Looks like runs down starboard side,but where it stops? Thank you
  2. R

    Cats 3176

    Upon spring commissioning,cats 3176 started up fine but both displayed trouble codes ":rolleyes:invalid throttle signal"and port had briefly "atmospheric pressure sensor"but has since been gone and replace by above.any ideas,or does it need a run?thank you,roger
  3. R

    350ql port engine crack

    In a 30 Catalina ,1973 Chris craft,the port engine has a crack in the valley of engine block welding has been attempted ,but unsuccessfull i have looked at "stitching " options but understand that heat from weld may have changed the composition of the cast iron,and therefore would not work. any...
  4. R

    cummins diesel identification

    can someone tell me what cummins i have with the serial number? 46845462,also lots of rubber debris in bilge right below where engine mounts up with zf transmission, a coupling problem or misalignment any suggestions would be appreciated,roger:cool:
  5. R

    Tamd diesel

    No start on Volvo tam d ,with Bosch injection pump,have supplied diesel fuel to injection pump and bleed return,no diesel fuel present at injectors or at discharge on pump,also glow plug circuit innoperative as no light comes on ,possibly related ?fuel cut magnet switch on top of pump has 11.03...
  6. R

    Fuel leak Volvo diesel

    In a 42 ft labelle trawler I have between the two Volvo diesels a fuel tank that is leaking into the bilge,this tank I believe is a return fuel tank or reservoir but has pressure coming out of the line when removed but still seeps when engine not operating.this problem was discovered over the...
  7. R

    5.9 no crank

    No crank on starboard engine glow plug circuit boat was sunk in the fall so maybe the glow plug relay/module is defective? Where is it located? Thks roger
  8. R

    Malibu ski boat

    Malibu wakeboard boat with a 340 monsoon engine and a Walter marine gearbox,I need to remove damaged prop shaft,strut and rudder for repair,DOES ENGINE and or gear box have to be removed first? As there doesn't seem to be access to the bolts through hull,thanks roger
  9. R

    chriscraft235 hp hard start

    have a 73 chriscraft with 235 hp hard start issues,wont idle,cant find timing marks on harmonic balancer but am getting #1 cylinder reference by compression tester and setting rotor to # 1 cyl,turning distributor while cranking tries to start and low vacuum,tried moving distributor to one tooth...
  10. R

    cumminsQSB 5.9 belts

    i have 2 cummins QSB 5.9 and am looking to change the drive belts serpentine large and the sea water serpentine and am looking for picture and part numbers as cummins is saying the sea water one is a v belt-thanks
  11. R

    89 evinrude 2o hp no start

    89 evinrude 2o hp been sitting three years out of the water no crank, tried solenoid,no crank, put 12 volts direct to starter, no crank,starter stuck? can it be repaired or replaced? thank you
  12. R

    366 crusader port engine blows 20 amp fuse on engine and will restart after fuse replaced

    36 carver 366 crusader port engine will blow 20 amp fuse after running for 10 mins or 60 minutes,will restart when fuse replaced,possible fuel pump? low pressure, fuel relay?thanks
  13. R

    Volvopenta D6370KA no hot restart without priming

    2009 d6370 straight 6 turbo in 29 ft hunt yatch,will crank hot but will not restart hot without manual priming fuel filter,checked history and history of running fuel dry,quit while running and very hard restart,tested fuel tanks for water,ok and for obvious leaks?no diagnostic codes present,any...
Back
Top