Logo
FULL SITE MENU

Search results

  1. T

    R P M Anynoe

    " I have 1990 90hp Tohatsu mot " I have 1990 90hp Tohatsu motor that red lines at 5600, last time out I could only get 5100 but I seem to be going the same speed as before. Any ideas what might cause this. Thanks. Bob. "
  2. T

    EVENRUDE Fouled plugs

    I would like to know what mig I would like to know what might cause brand new plugs to foul after just 3 hours of trolling. This is a 1993 9.9hp. Any thoughts Joe/ Anyone ?
  3. T

    90 horse TOHATSU

    " Motor ony reaches 4200 rpm o " Motor ony reaches 4200 rpm out of usuall 5400. Pulled plugs & cleaned ran fine two times out, yesterday started motor and same thing, pulled plugs and found that the top two plugs where burning perfect nice dry brown color the bottom plug was wet as if getting...
  4. T

    MERCURY 200

    " I have a Mercury 200, serial " I have a Mercury 200, serial # 3069417, can anyone tell me what year this motor is? "
  5. T

    JOE NEED HELP BAD 1993 99 EVINRUDE Trollingbob

    " Joe; I started to install th " Joe; I started to install the charge kit 174037 you said was needed for my motor and everything went fine until I came to the the rectifier, for some reason I can not find two holes that line up to install said rectifier much less the terminal block the OMC...
  6. T

    Joe 1993 99 Evinrude

    " Joe; I now have my charging " Joe; I now have my charging kit and it looks like a pretty straight forward job, the instructions call for a coil locating ring, is there anywhere I can buy this tool? Allso I was wondering if I mark the flywheel in say two places before removeal and line those...
  7. T

    JoeReeves b93 99hp evinrude

    " Joe, I've sent for the b " Joe, I've sent for the battery charge kit #174037 you recomended now my question is does it take a special puller to remove the flywheel, one I might be able to rent or will I have to take it in to the shop to have it removed? Thanks for all the time you give to...
  8. T

    Joe update on 1993 99 Evinrude throttle friction amp charge sys

    " Joe, I got to look at a micr " Joe, I got to look at a microfish and it showed a friction device that looks like a hose clamp with a thumb screw located at the base of the throttle handle, OMC part # 174741. I'm going out to the boat tomorrow and look but I'm positive it's not there,probably...
  9. T

    1993 Evinrude

    " Joe, I wanted to say thanks " Joe, I wanted to say thanks for the part # for a battery charge kit, saved me $120.00 right off the bat.My question now is my friction button seems to be broken it wont hold the throtle in any position I currently run a bungie cord around it to the back of the...
  10. T

    1993 Evenrude

    " I would like to add a chargi " I would like to add a charging system to my trolling motor but I can't seem to find an altenator kit now that OMC has changed hands, does anyone know if I could use one off an older motor? The motor is a 9.9hp Evenrude. "
Back
Top