Logo
FULL SITE MENU

Search results

  1. T

    '03 Honda 225

    Getting solid red light on three light panel with beeps one second on and one second off. Shut down and start up both gone but occasional happens again particularly at lower RPM's. Motor runs just fine. O2 sensor???
  2. T

    Help To Identify This Part

  3. T

    Honda 225 Internal Anodes

    What would be estimated hours of labor time only for mechanic to replace the internal anodes, thermostats, temperature sensors, and both pressure relief poppet valves on 2003 Honda 225?
  4. T

    Honda BF225 Top Cover Kit

    Anyone have any idea how to replace this part on my cover? Any help would be appreciated. Picture did not attach. Top cover kit on the cowl.
  5. T

    Honda BF225 Top Cover Kit

    Anyone have any idea how to replace this part on my cover? Any help would be appreciated
  6. T

    Honda 225 Flush Port Cap

    After flushing my 225 and trying to reattach the hose to the flush port on bottom of the extension case on starboard underside of extension case, seems the connection fell out or pushed up inside the case. I think it is only a cap with hex nut so ordered and will try to replace. There is...
  7. T

    Steering Torque Trim Tab Repair

  8. T

    Steering Torque Trim Tab Repair

    The receptor bolt hole for my steering torque trim tab has severely eroded allowing the bolt attaching tab to lower gear case to fall out. About 1/4 inch of the bottom surface of hole is gone and hole is widened. Giving consideration to tapping and using some JB Weld to hold a helicoil in...
  9. T

    Replacing Engine Cover Gasket

    Is adhesive required when replacing the engine cover gasket?
  10. T

    Using Honda Computer

    When tech uses the computer to diagnose a problem, is there something that must be unplugged or bypassed? If so, what would be the consequences of not reconnecting whatever was disconnected and then trying to run the engine? Would it run at all or just run extremely bad?
  11. T

    Honda 225 WOT Problem

    I have a problem that began the first time I put boat in water this season. Started and idled fine and would run up to about 4K rpm but would not respond to throttle beyond that. Had local mechanic drain VST, replace all three filters, and pull/check the plugs. Also added some injector...
  12. T

    Restricted RPM's

    2003 225 starts, idles, and runs very smoothly to about 4800 RPM's (max has been 6100 rpm's) but throttle totally unresponsive beyond that. Boat sat in rack for several months and this first time being splashed since. Low pressure filter and separator changed. I suspect problem with high...
Back
Top