Logo
FULL SITE MENU

Search results

  1. T

    Flywheel Nut Torque amp Oiler Wick 1962 10HP Johnson QD23

    "1962 Johnson Seahorse 10HP QD "1962 Johnson Seahorse 10HP QD-23 I am replacing ignition components (tune up kit, coils, wires). What is the proper flywheel nut torque? Also, the iginition kit I purchased has a new oiler wick for the points cam. I have not recieved the kit yet, but I am...
  2. T

    Johnson 1962 10HP Fuel%3cIMG SRC%3d%22httpwwwmarineenginecomdiscusclipartproudgif%22 ALT%3d%22O%22 BORDER%3d0%3eil Mixture

    "What is the fuel:oil mixture "What is the fuel:oil mixture ratio for a 1962 Johnson 10HP QD-23. I think it is 24:1 and I called Johnson to confirm, but the tech was not so sure on that age motor. I am questioning it since I am getting a lot of gray milky discharge from the drain holes in the...
  3. T

    10HP 1962 Leaky Needle Valve Packing Nut

    "I just rebuilt the carburetor "I just rebuilt the carburetor on a 1962 Johnson 10HP QD-23. The high speed needle valve is leaking between the packing nut and the needle. I put in 2 packing washers when I rebuilt it as shown in the OEM parts diagram, but the rebuild kit came with many more...
  4. T

    Carb High Speed Needle Valve Leak 1962 10HP Johnson

    "I just rebuild the carb. on a "I just rebuild the carb. on a 1962 10HP Johnson QD-23. The high speed needle valve is slowly leaking fuel between the needle itself and the packing bushing/nut. I have tightened the bushing to the point that I practically cannot rotate the needle valve, but there...
  5. T

    Shift Rod Bushing amp Oring Removal 1962 Johnson 10HP

    1962 Johnson 10HP QD-23 I a 1962 Johnson 10HP QD-23 I am replacing all the seals and water pump in the lower unit. I am using a Seloc manual as a guide. The Seloc manual states that a special punch tool must be used to remove the brass bushing and o-ring for the shift rod seal. I am...
Back
Top