Logo
FULL SITE MENU

Search results

  1. M

    6.0 MPi Winterization steps

    Hi All, Any tips on winterizing motor? Can I: 1. Shut off fuel line, add stabilizer to Fuel Filter, run for five minutes. 2. Go by owners manual, pull each plug, etc... I'd prefer 1 if it's as effective as 2. thanks Mark
  2. M

    2003 4 hp re-assembling lower unit

    Hi All, 2003 4 hp 2 stroke. I replaced impeller and need to re-assemble lower unit. I have shift lever in reverse and unit tilted to 90 degrees. I can get unit to around 1 1/2 inches close, but am having hard time lining up shift lever rod with hole in top of upper unit. Any tips are...
  3. M

    Adjusting Neutral position.

    Hi All, I need to adjust neutral position for a single control. How is this done? At control or at transmission? Thanks Mark
  4. M

    6.0 Oil Level and Oil pressure

    Hello All, My question concerns checking oil. I'm a bit puzzled by readings. If I check the engine after it's been cold, the level appears around 2" above full line. If I then clean dipstick and insert back into tube, the level reads between add and full. Also, What is the normal operating...
  5. M

    Exhaust Elbow Leak 60 MPI

    "Hi, I have a FWC 2004 6.0 "Hi, I have a FWC 2004 6.0 MPI that has a slight leak on gasket between exhaust elbow and exhaust manifold. I need to replace gasket. 1. Should I use thin coating Mercruiser Perfect Seal on gasket surfaces prior to installation? 2. What is the torque...
Back
Top