Logo
FULL SITE MENU

Search results

  1. K

    Ignition Timing

    Hello, I have not posted here in a while but I have a question.A friend of mine reciently bought a used boat.All is well with it however (it is a ski boat) after it is run pulling skiers and shuts it off, it has a hard time restarting. Sounds like the timing is advanced. The engine is a 351 Ford...
  2. K

    1957 Evinrude 18 Hp fastwin

    "Hello fellow mariners. My que "Hello fellow mariners. My question is,when my motor is in the tank, it runs well but it seems to stop pumping for a seckond or to. If I rev it up a bit it pumps well. I have replaced the water pump, housing,gromet,and the base plate.All apears normal but the...
  3. K

    99 johnson Water Pump

    "I just bought a used 9.9 john "I just bought a used 9.9 johnson. I have the impeller and wish to change this. Is their anything special that I need to know? This motor is the low profile model.I have changed a impeller on my 1957 fastwin with no problems. Is their anything special that I may...
  4. K

    1957 Evinrude controls

    "I enjoy the forum greatly. Ho "I enjoy the forum greatly. However, I was wondering if anyone has a set of control cables that will fit my 1957 18 hp Evinrude. The electric starter and choke works and I was wondering if these cables are still available. Thanks, Ken"
  5. K

    Gasoline octaine

    "Well seeing as my 57 is now r "Well seeing as my 57 is now ready to go and pumping well, (pumping well get it) anyway I was wondering. Seeing as how an outboard motor is running at a constant temperature that is much cooler than saws ext,is it permissable to use the lowest octane available? If...
  6. K

    1957 Evinrude water pump

    "Well after replacing the wate "Well after replacing the water pump with a kit, the motor now pumps like a dream in a trash can. My question is that the stream seems to slow down a seckond or to of idle then it picks back up again. No leaks but other than this all is well. I had to fabricate a...
  7. K

    Old gas tanks

    I was just wondering ( I m I was just wondering ( I may be in the wrong section) But I have two extra gas tanks for the old Evinrude/ Johnson. These tanks have the two line steup. Both tanks hold pressure and yes the tanks do pump gas. No rust.
  8. K

    15922 1957 Evinrude 18 hp Water pump

    "Hello all. Last year I replac "Hello all. Last year I replaced a water pump in my 1957 18 hp evinrude. Well I started the motor in a clean trash can and it was pumping water at first.Then it quit. The water level was more than adequate. Well upon teardown, The center of the coller seperated...
Back
Top