Logo
FULL SITE MENU

Search results

  1. K

    Slightly Perplexed

    1988 OMC 4.3L V6 - Points Ignition, 2bbl Rochester Carb(amature rebuilt once, pro rebuilt once), New Long Block, Wing Manifolds, New Water Separator, Checked Fuel-OK Fresh this month, clean. 4yr old plug wires (they look marine), Age of coil unknown, New Points(readjusted and checked multiple...
  2. K

    Evinrude Helps US Marines Step Off the Gas

    "http://www.boats.com/ "[url=""]http://www.boats.com/blog/2009/11/evinrude-helps-marines-step-off-the-gas/ The Evinrude 55MFE is based on the Evinrude E-TEC 864cc twin-cylinder, two-stroke powerhead. It uses the same type of direct-injection found on standard Evinrude E-TEC outboards, but...
  3. K

    NEW 165hp Inline 6 Sierra Marine RebuiltReplacment Carb

    "NEW 165hp Inline 6 Sierra Mar "NEW 165hp Inline 6 Sierra Marine Rebuilt/Replacment Carb - now about 1 yr old.. Was working on the boat the other day, noticed that the Idle adjustment screw is too long causing the Max Throttle opening to not be the Max. :-( Also found the Choke plate...
  4. K

    1984 Force 125 Dies going into Reverse

    "1984 Force 125 - Dies going i "1984 Force 125 - Dies going into Reverse Cleaned and adjusted the carbs so it starts quick and idles good in gear in the water (tied to a dock), if I go back to N then to REV, the engine sputters and dies... Any Ideas ? Lower unit had the impeller changed and...
  5. K

    Power Steering Install PRE 1980

    "So I have a 1974-1976 Merc an "So I have a 1974-1976 Merc and I want to ADD power Steering setup, the pump and cooler I can handle.. but I'm not sure what I need at the transom plate, any one have a picture of that year range ? other than the not so good parts pics. thanks brian"
  6. K

    2008 VP 50GL Hard Starting and Stalls when Shifting INTO Gear

    "My nephews Glastron 2008 V "My nephews Glastron 2008 VP 5.0GL - Hard Starting and Stalls when Shifting INTO Gear Found the Accell pump lever from Throttle Accel Pump Cam to Accel Pump to Be corroded almost fully to shaft, very hard coming off, used 2 1/2"(ish) sized open end/box end...
  7. K

    Mercruiser 292

    "<font size=""+1"">Looking to "<font size=""+1"">Looking to see if anyone has pictures of the front right and left side of a mercruiser 292 block ( i'm interested close to the timing cover ) Also I'm interested in the plate below the carb, where the carb bolts to the manifold, I'm looking to...
  8. K

    Transom replacement

    "Ok, I'm very nervous, I A "Ok, I'm very nervous, I AM replacing the transom cause it's rotted badly (poorly sealed Starcraft Islander stern) and am almost ready to remove the gimbal housing and transom plate, I soaked the bolts and nuts with Liquid Wrench, and plan to have some MAPP gas on...
  9. K

    Rear motor supportboot

    "I did one, it was easy, to gi "I did one, it was easy, to give you an idea, (sorry it's been a few years) remove the screws from the boat on the outside of the boot ring, move the metal ring out of the way(no need to take it off), then pull the boot away from the boat, you'll see a big clamp...
Back
Top