Logo
FULL SITE MENU

Search results

  1. H

    Need recommendation for anti-corrosive spray for a 90 Honda going to be in salt water for 3 months

    As the title says... I have a customer who is taking a fairly new Honda 90 on a workboat to saltwater for a job for three months. Being in a fresh water area, we only use light weight stuff. I would like to spray something on the motor before he picks it up. I know I will get many...
  2. H

    2006 Honda 9.9 4-stroke (BF9.9D) Impeller

    That section of the manual goes into how to disassemble the complete lower unit. You have to read past some of that. Here is a customer handout for how to change the waterpump with pictures.
  3. H

    Honda 15 hp 2005 long shaft question

    Your donation will be letting us all know the outcome of your efforts.... You still have to prove once and for all what year and size of the motor. If you can not read the serial number on the frame, there is also a serial number (different number) on the power head. I am not at work (and...
  4. H

    2004 bf150 alarm

    I don't want to say that they are wrong...but....they are not correct. That is more polite. Shorting the light green wire with the black will give you the fault codes. See the picture with the shorting plug. I tried to be sure you could see the colors, the wire on the shorting plug and the...
  5. H

    Anyone have the new Honda NMEA digital gauges?

    I have not had the opportunity to put these in yet. Did a dealer install with a new motor or did you install? Were there instructions for setup with the gauges? I have not seen any yet. We are due to get updates on most of our technical info. I would think there is some set up required...
  6. H

    Bf225 warning beeper

    This picture should show you where the Indicator Wire Harness 6 pin Connector should be located. Mike
  7. H

    2007 50 hp water pump replacement

    I agree with racerone. One hour is enough to do change the pump and even backflush the system. Honda does have a how to for consumers with instructions how to change the water pump. The document says it is for the BF40D and BF50D. These are the current models for those horsepowers. The...
  8. H

    Honda 225HP Intermittent Prolonged Alarm

    If you have only two lights on your key switch panel...one is and over heat and the other is the oil pressure. If appears, whomever installed your engine did not put the addtional two lights in to save a couple of bucks. I recommend that you purchase a 32340-ZW7-000AH light panel. You should...
  9. H

    1998 Bf130 will not start after warm up

    Here is a picture of the way the water tubes should be connected. I am assuming your are referring to water tube D and water tube B. Hope this makes things more clear. Mike
  10. H

    BF90 not reaching 5500 RPM, runs great not a prop issue

    Does your tach look like this one? If so, it is only compatible with BF35-BF50 pre 2006. It will read incorrectly with the 90 HP. The part number that you listed is not for this tachometer. Mike
  11. H

    What to expect by switching props.

    If you go to the 13 x15 your rpms will go down and you will continue to bogg down your engine. Not good... It appears that if you go to a 13 3/4 x 13, your rpms will go up...your take off will be better...and the speed will be just as good, if not better than now. Check out the following test...
  12. H

    O2 Sensor warranty extended for BF200 and BF225

    Just to supplement chawk_man...this applies to BF200A, A2 - KO Models with serial numbers BAEJ-1000001 - 1509999 and BAFJ-1000001-1509999 and BF225A, A2 0 K0 Models with serial numbers BAGJ-1000001 - 1509999 and BAHJ -1000001 - 1500598 Here are copies of the letters sent to registered...
  13. H

    225hp Honda beeping after short time

    Glad you found the problem. On your first post, you said that you shorted the red plug to check for codes. The light that you were supposed to watch (PGMFI) was not there. For future troubleshooting, you should have two more lights. One for PGMFI and one for Charging. I do not know how old...
  14. H

    BF225 Intermittent Beep

    It appears that I have ruffled some feathers. I did not know there was a honda_dude when I typed in a username 447 posts ago. Sorry about that, honda_dude. I have been going by my first name until they changed the web site, after that, only hondadude appeared. If there is a way to easily change...
  15. H

    2003 BF50A shift problems

    Yes, it is most likely an adjustment. You will probably have to pull the boat back out of the water to do it. They probably did not connect the two part shift shaft back together correctly. Once you find the nuts, it will probably take you about two minutes. So bare with my rambling... After...
  16. H

    Help with greasing the fittings and zerks on honda 150

    You are right. The fittings on the hydraulic steering is where the steering is bled. There are two zerks on the tilt tube just behind the hydraulic steering unit. It may be impossible to get to them without taking off the steerin unit. There is also one zerk on the port side of the vertical...
  17. H

    BF75S Not firing

    "Now that you mention it.... "Now that you mention it.... I had a customer a year ago that called from another state looking for one. Honda could not give me any specific leads...but... I happened to have one of the BF75 in for service. Resistance wise and physically, the pulser coil is...
  18. H

    BF225 SB#56 repair

    Congratulations! Looks like y Congratulations! Looks like you are doing good... Hope you cleaned any debris out your oil pickup screen before you put it back in. Try to keep you motor tilted up enough so that the exhaust reliefs (The two ports in the mid rear of the engine that go...
Back
Top