Logo

Search results

  1. G

    Kamd 44p

    Help my friend has kamd 44 p he's getting a code 11 saying engine not in neutral reset it and if boat sits for a few days it loses the setting Engine is 2002and on a 25 ft. Carolina Classic
  2. G

    Perkins 354.6 for sale

    I got a 354.6 with gear going to need injection pump rebuilt runs Oil cooler is 2 years old $1200
  3. G

    354.6 injection pump removal

    Any help with removing and installing pump thanks
  4. G

    354.6 injection pump

    My pump is leaking fuel it looks like it coming out the screw with the spring on it mixing screw? Is there away to fix this or does pump need replaced thank you
  5. G

    Perkins 165 HP oil psi

    I put new sender on 20psi at start up drops down to 8/10 psi after running I got a new gauge and sender that were supposed to match same thing happened I got another sender from Foley in Ma. That didn't help either I put a snap on test gauge on 38psi at start up and held 30 psi can't figure...
  6. G

    Perkins 354 165HP oil

    I got an older 354 165HP pre 1978 I replaced the oil sender pressure still low 20 lbs. I run the boat by the time I get back to dock oil is really low but eng. sounds fine then I got new sensor and gauge same thing Wondering if oil is the right kind I was told to use sae 30 thanks
  7. G

    Perkins 165 HP id #

    I'm having a hard time finding the stamped number on engine need it to order parts 165 HP 354 series
  8. G

    Perkins 165 HP

    I have an old 165HP having a hard time finding eng. # on block I need to order and oil sencor anyone no where I can get one thanks
  9. G

    Perkins 165 HP

    I'm looking at a boat with a 165 HP wondering if parts are still available and if is a good engine not sure how many hours are on it Thanks
  10. G

    tamd 41a sea water pump

    Hello out in boat today noticed sea water pump leaking it looks like it coming from bottom where hose comes in there's a plastic ring it looks like it is cracked also is it a big job to replace pump thanks
  11. G

    hs1 transmission

    good morning , im losing oil not leaking in bilge wondering if could be a bad trans. cooler that might be where alot of smoke is coming from any suggestion thank you have a good weekend
  12. G

    Kamd44p

    my buddies boat has a kamd44p with a jack shaft in it when in neutral it sometimes goes into gear anyone have this problem and no how to fix thanks, goody
  13. G

    tamd 41a

    Need help looking for inspection cover off a 41 its the plate on port side under manifold thanks
  14. G

    tamd 41a blowby

    Blowby i was wondering if there is a o ring that might of let go on crank case breather tube i'm getting oil coming out under filter thanks
  15. G

    diesel tex polisher

    wondering if anyone ever used this or any other polisher said to reduced soot and exhaust smoke i have a tamd41a in my boat i know their smokers thanks, goody
  16. G

    tamd41a gauges

    hello looked at engine today found red wire off alterator problem solved
  17. G

    tamd41a gauges

    hello everyone coming back in today lost power to all my gauges back at dock had to shutdown engine at engine no power at key also wondering if anyone knows what problem is thank you goody
  18. G

    TAMD41A overheating

    thanks for reply looked in eng, compartment found 7 ft, hose from sea cock to trans, cooler crushed in 2 spots replaced then flushed out trans, cooler took cover off the back of innner cooler found a fin that directs water broken off one just about ready to come off removed and took over to shop...
  19. G

    TAMD41A overheating

    thanks for replies to check elbow do i just remove plugs on elbow and rev eng. in neutral to check flow and is there anyway to check raw waterpump it looks like it pumping plenty of water i replaced impeller in fall and if i got to check cooler i guess it has to come off eng. to clean thank you...
  20. G

    Tamd41a

    had boat for a ride tonight on the way back engine got a high temp. alarm shutdown let it cool for a while ran boat back slow i know there are two thermostats hoping the one for running at higher rpms is bad anyone have any input thank you, goody
Back
Top