Logo
FULL SITE MENU

Search results

  1. L

    Fuel Pump wiring

    Got it. Thanks
  2. L

    Fuel Pump wiring

    Hello. I'm in process of trying to get this new to me boat running safely. My question has to do with proper wiring of the fuel pump. I have a 1996 Crownline 225br with a 454 Mercruiser. (serial # F810329) I replaced the electric Edelbrock fuel pump 2 times. The previous owner had wired it...
  3. L

    Starting problem

    That was it! Thank you! I connected to the small post on the solenoid nearest the block. Thank you.
  4. L

    Starting problem

    So I took the ground wire off. It wasn't in bad shape at all. I cleaned the connectors. I removed the new starter and sanded were it butts up to the block since I thought it was a source of ground. The boat still just clicks when I try to start. Not sure if it could be any of these purple wires...
  5. L

    Starting problem

    I'll check this and report back. Thank you
  6. L

    Starting problem

    I have 12.8 v on the red slave terminal. In answer to why I changed the starter -I took the starter off and had it tested at Oreilly Autoparts. It was faulty. The bendix wouldn't fully engage. I just got the boat and took it out for a test run. It left me stranded until I tapped the starter...
  7. L

    Starting problem

    I tried that and nothing. I have power to the starter but no action at all
  8. L

    Starting problem

    I also have 12 volts to the starter solenoid when key is pressed. But starter is silent. I took a test light and put one end on the + side of battery and the other end touching the solenoid and it shows that the solenoid is grounded. Before installing the starter I bench tested it and it...
  9. L

    Starting problem

    I tried touching the 12v starter lug to the starter solenoid and nothing
  10. L

    Starting problem

    Hello. I have a 454 mercruiser that only clicks when I turn the key. The click comes from upper part of engine. I've replaced the starter and battery. I've also tried to jumper the 2 lugs on top of the slave solenoid and get no clicking at all. Any suggestions would be greatly appreciated.
Back
Top