Logo
FULL SITE MENU

Search results

  1. C

    VRO Question ?

    Can a VRO system add to much oil to the fuel system? Motor seems to use to much oil, smokes, and plugs look a little oily. Been around 2 strokes since I was a kid in the late 60's and early 70's running the crap out of motorcycles so i know a little bit about two strokes. What I have - motor...
  2. C

    1992 Evinrude 200 horse spark advance link assembly.

    1992 Evinrude spark link assembly for a 200 horse. The spark link assemble had an adjustable handle on the end of the link assembly. Inside the handle is a spring, spring cup and a stop adjustment that hold the spring and cup in the end of the handle. The spring inside the handle puts pressure...
  3. C

    1992 200 horse Evinrude idle slow

    Slow idle with 1992 200 horse Evinrude. Use to idle about 750, lubricated all the linkage from the throttle cable to the carburetor, now idles about 500 rpm. Dies quite often in gear. I have watched the factory video and read the manual and understand the proper procedure to set all the...
  4. C

    Painting small repair on older Ranger baot.

    I put a small hole in the side of my Ranger, got into the dock. Fiberglass repair area of about the size of the palm of your hand. I have the gel-coat and color additive from Ranger. I only have to paint and area of about 6'' wide by 50'' long to have a small break point for a color match. I...
  5. C

    1992 Evinrude 200 Horse VRO

    I have a 200 horse Evinrude 1992 model with a VRO pump on it. Motor run great no problems. Bought used a couple years ago, and I always like to do preventive maintenance and stay abreast of problems. What does it entail to install a rebuild kit in the pump, wanting to go through the pump this...
  6. C

    Starter Bendix

    I have a 1993 Evinrude 200 horse and a 1990 Johnson 40 horse. Both of the starter bendix will unlock ( kick out, or spin out ) when trying to start the motors. Not all the time, but they are getting worse. Are they like a starter bendix on a car starter. Where the one way clutch is going bad...
  7. C

    Have a Evinrude with no engine identification plate on it.

    I have a 1993 Evinrude 200 Hp V-6 Limited Editions ( Stickers on bonnet Looks factory ?? ) Cannot find engine identification plate any where on the motor. There is a freeze plug on the back of the engine toward the top of the block that has a code G3012357 imprinted in it. I saw on this...
  8. C

    1993 Evinrude 200 tach problems and battery discharge

    1993 Evinrude 200hp on a 1993 Ranger 397v. Installed new tach and it works intermittently, old tach worked intermittently. Using an ohm meter, checked 12v power wire to source, checked ground wire to grounding block and back to battery, checked gray wire back to terminal block on top of engine...
Back
Top