Logo
FULL SITE MENU

Search results

  1. B

    Avon Rigid inflatable helm relocation.

    My 15'6 Avon/Zodiac 4.65 Rib is in great condition, but rides rough unless we weight the bow. The factory side console location and rear bench seat (you drive from) seems too far back. I see a ton of crab boats with the helm in the bow. I know this is for work and opening deck space, but it...
  2. B

    prep and paint for a welded aluminum boat

    I have a Scandy White welded aluminum 16' boat that I am restoring. I plan on removing all the carpet and glue and painting the topsides. Does anyone have solid experience on coating aluminum? I am definitely going to scrape, sand and clean the aluminum (aluma brite last). Then I wil use...
  3. B

    Can anyone diagnose a Mercury 30hp EFI accurately?

    I have a 2006 Mercury 30HP EFI. It starts and runs perfect, until I shut it down when hot. Then it will not start and run in idle. The hotter it gets the worse it is, until it will not start. I ran it in the yard and the same thing. It starts and runs perfect, then about 2 minutes later...
  4. B

    Please HELP me get my EFI running

    Chris, I think I found some more interesting information out while testing. Below is a picture of my service manual and, in pencil, the ohm measurements I was getting. Today, I found some instruction on a simpler way to test a 3 phase rectifier/regulator. Using my multimeter...
  5. B

    Experience with a Rinda TechMate Pro?

    Has anyone used a TechMate Pro on a Mercury 25 or 30 HP EFI ? Or a Nissan or Tohatsu 25/30 (same ECU)? I think my ECU is dead (other post titled "Please HELP me get my EFI running". It looks like the TechMate pro will only work on a running engine with this ECU. Bummer. I bought it to...
  6. B

    Anyone have 25 or 30 HP staring issues? ECU? erratic Tach?

    Has anyone had an issue with a 25 or 30 HP 4 stroke that would not start? I have a Mercury 30 HP EFI ELPT 2007. It is the same engine as the Tohatsu and Nissans. I got it used. It ran OK for 2 times out on the water. The second trip it shut down and would not start. I get no pop when...
  7. B

    Please HELP me get my EFI running

    Chris, The regulator is held down with x2 SS screws. I removed the small line (drain possibly). I pulled out the regulator with the return hose attached. The regulator has a rubber seat under it. It has a brass tube with 2 o rings on it that goes down into the VST. I do not see...
  8. B

    Please HELP me get my EFI running

    Chris, Took the VST back apart today. The grommet at the top of the HP pump looks good and seated perfect. I attached a pic before I pulled it off. I also removed the screen from the HP pump. It took some work and I wonder if it is even made to be removable, seems like it...
  9. B

    Please HELP me get my EFI running

    Hello everyone, I could use some expertise and troubleshooting help. Sorry for the long post, but, details....... I have a Mercury 30HP EFI 2006 with power trim and remote control (NEW). I purchased it used. It appeared to start and idle perfect. I noticed that the factory LP fuel...
Back
Top