Logo
FULL SITE MENU

Search results

  1. E

    1990 Evinrude, 40HP, Model VE40TLESR, Power Tilt/Trim question

    I have this motor on a pontoon boat that has been sitting in storage for nearly 2 years. After installing the battery, the Power tilt/trim initially worked to lift the motor all the way up. Then it seemed to have intermittent issues lifting the motor on later tries. Then after sitting a few...
  2. E

    1990 Evinrude, 40HP, Model VE40TLESR, Power Tilt/Trim question

    I have this motor on a pontoon boat that has been sitting in storage for nearly 2 years. After installing the battery, the Power tilt/trim initially worked to lift the motor all the way up. Then it seemed to have intermittent issues lifting the motor on later tries and after sitting a few days...
  3. E

    40 HP Evinrude, 1990, Model VE40TLESR, battery charging system not working adequately

    I changed the voltage rectifier on this engine already, but I still only get about 12 VDC (measured across the battery leads) when running the motor at any RPM with the navigation lights on, which eventually drains the battery. I get up to 13 VDC with the lights off. What is the next thing to...
  4. E

    40 HP Evinrude, 1990, Model VE40TLESR, Gearcase & Bearing assembly to replace water pump/upper seals

    40 HP Evinrude, 1990, Model VE40TLESR, Gearcase & Bearing assembly to replace water pump/upper seals I am looking for a known procedure to follow to replace the water pump and upper seals. I have already changed the seal and O-ring on the prop shaft, to try to correct a problem with water...
  5. E

    40 HP Evinrude, 1990, Model VE40TLESR, Acceptable Compression range

    What is the acceptable piston/cylinder compression range as measured at each spark plug hole? And if there is a certain procedure to follow to due a test please advise. I got 110 PSI, by threading the hose of the compression gauge into each spark plug hole and turning the engine over for about 5...
  6. E

    40 HP Evinrude, 1990, Model VE40TLESR, Shift Rod grommet # 0321452

    I was changing my spark plugs and checking things over on this motor when I found a grommet (it looks like # 0321452) laying loose below the throttle linkage side of the engine. I have looked at the detailed parts breakdown and can't figure out where it goes. Any help would be appreciated...
  7. E

    40 HP Evinrude, Model VE40TLESR, Gearcase disassembly, #25 Bearing housing Assy. in particular

    I want change the shaft seals and any other parts that look worn (the Anode housing looks deteriorated) as water is getting into my lower unit oil. What is the process to get the item # 25 bearing housing out of the lower unit? I the following parts off already: Prop, thrust bushing, anode...
  8. E

    40 HP Evinrude, Model VE40TLESR, battery charging system not working

    I have diagnosed part of the problem is that the voltage rectifier has the Red wire fried. I want to check the Stator Assembly while I am at is to verify it has the correct resistance. What is the correct resistance value for the 3 wires on this assembly (Yellow, Yellow/Gray, Yellow/Blue)...
Back
Top