Logo
FULL SITE MENU

Search results

  1. J

    Temp sensor issue

    1988 Regal w/ Mercruiser, 175 hP, V6 #OB967952 I just installed new temp sensor, subtitute for #806490T. The needle on the temp gage goes over to the beginning of the red line for "H" and stays there while running. The engine is NOT running hot. After a cool down the needle retreats. I think...
  2. J

    NEW Trim sender problemt

    1988 Regal Sebring 4.3 Alpha One, gen 1. - I installed a new set of trim limit & sender by Kemimoto. The gimble houseing bellows and hose are all in and buttoned up. When it came time to adjust the limit, no problem. Before attaching the sender I wanted to check the dash dial so I turned the...
  3. J

    Shift cable adjustment

    This project is almost finished. I am down to connecting the lower shift cable end to the engine. Do know the the exact distance for the adjustment distance between the center of the attachment bolt and the the center of the adjustable barrel? I know the distance for a Alpha One, gen 2 is 6". Is...
  4. J

    Mercruise Bellow adhesive problem.

    1988 4.3 Alpha One, gen 1. - I am working alone, (except for the wife who holds the light). I have the the transome end of the U-jpoint and the exhaust bellows installed, glued and clamped solid. I am now ready to attatch the drive end of the u-joint bellows. directions say to apply 50 mil...
  5. J

    U-joint Bellow install

    1988 4.3 Alpha One, gen 1. On the u-joint bellow there are 2 flat spots on the last rib at one end of the bellow. Where do they go? towards the transome or toward the drive? There is a metal clip on each of the bellow, where do they go? up or down?
  6. J

    Trim sender, limit switch connection question.

    I am replacing the trim sender & limiter on 1988 Alpha One, gen 1. I noticed that there is purple mark on the original wire for the sender that matches the purple wire in the engine compartment. The new wire does not have such a purple mark. There are no marks on the the limiter wires. Question...
  7. J

    Shortcut to replace trim indicator and trim limit switch

    I have a 1988 Regal with a Mercruiser 4.3 Alpha One, gen 1 out drive. I am in the process of replaceing the gimble bellows, hose, gimble bearing lower shift cable and the trim switches. I am at the point of reassemby. I have removed the lower unit and the gimble housing. I did not remove the...
  8. J

    What model do I have

    I have a 1988 Regal Sebring with a Mercruiser 4.3 Alpha One, serial #OC422596. Can any tell me if that is a "gen 1"?
Back
Top